ZyXEL PLA-402 v3 LAN Adapter Last
ZyXEL PLA-402 v3 LAN Adapter Driver
Simply plug one adapter into an outlet or coax near your router and connect them with an Ethernet cable. Go to another room and plug another adapter into an Missing: Must include: The new-generation PLA v3 reduces power consumption over 22% comparing to previous Powerline Ethernet Adapters; and when there is no Ethernet link. Powerline Ethernet Adapter Series (PLA/ v2// v2/ , PLA v2, PLA v2, PLA, PLA v2 and PLA using the PLA-4xx Series The PLA-4xx Series Configuration Utility version (AG) may be referred to as.
|Supported systems:||Windows XP, Windows Vista, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 10, Windows 10 64 bit|
|Price:||Free* [*Free Regsitration Required]|
ZyXEL PLA-402 v3 LAN Adapter Driver
This guide is a reference for a series of products.
Therefore some features or options in this guide may not be available in your product. Screenshots and graphics in this book may differ slightly from your product due to differences in your product firmware or your computer operating system.
Atheros Power Packet Utility
Every effort has been made to ensure that the information in this manual is accurate. It contains information on making your hardware connections.
The following generic icon is used to represent all PLA models. In this User s Guide the electrical wiring network is referred to as the powerline network. The HomePlug AV standard specifies how network devices communicate using standard electrical wiring.
This User s Guide covers the following models: You can directly plug an electrical device such as a router or computer into PLAs with an AC power pass-through socket to supply power to the device. One has an Ethernet port on the top and a power plug at the bottom of the rear panel. One has an ZyXEL PLA-402 v3 LAN Adapter port on the bottom and a power plug at the top of the rear panel.
The power plug varies depending on your region. The following figure is the front panel of the PLA.
ZyXEL PLA v2 Support and Manuals
Use the lights to determine if the PLA is behaving normally or if there are some problems on your powerline network. The Power LED blinks when it is in standby mode. Refer to Section 1. Off The PLA is not receiving power.
Wired LAN Adapters ZyXEL
The data transfer rate is greater than 40 Mbps. Amber The PLA detects another powerline adapter.
Red The PLA detects another powerline adapter. Off The HomePlug port does not detect another powerline adapter. Blinking The PLA is communicating with a networking device connected to it.
- ZyXEL PLA User's Manual
- Download Library ZyXEL
- Zyxel Drivers
- Wired LAN Adapters
The data transfer rate is greater than 80 Mbps. It goes into standby mode when there is no Ethernet connection.
When you plug the PLA into an electric socket, it waits for an Ethernet connection. When no connection is detected after sixty 60 seconds, the Power LED blinks indicating that it is going into standby mode. The same process occurs when you disconnect the PLA from a previously ZyXEL PLA-402 v3 LAN Adapter Ethernet connection.
See Chapter 3 on page 19 for instructions on installing the utility. Devices can securely communicate with each other at high data transfer rates.
Your network can be further expanded by plugging additional PLAs into other outlets in your home and connecting other computers or network devices for example, a printer to them. Refer to your Quick Start Guide for hardware connection information. The following table describes the differences between the passwords.